MobiCam Digital DL Manuel d'instructions télécharger pdf (Page 10)

INSTALLATION & SETUP

The MobiCam Digital DL Monitor is designed to be powered by either baeries

or the AC/DC adaptors. You can also purchase a rechargeable baery pack (item

# 70077) available at getmobi.com or retailer to use with your monitor.

Using AC/DC adaptor:

• Plug the connector of the AC adaptor into the DC Jack on the unit (g.

9 & 17).

• Plug the power cord into an outlet.

• Switch the power plug to the ON posion (g. 7 & 16)

• The power indicator lights will illuminate once the units are turned on

(g. 4 & 12)

Using Baeries:

• Remove the baery door at the boom/back of each unit by loosening

the child-safe screw and sliding the cover downward to release.

• Both units can use 1.5 volt AA size baeries. (Always use baeries of

the same brand and age, alkaline baeries are recommended)

Insert 4 AA baeries into camera and 5 AA baeries into the monitor.

• Replace the covers by aligning the tabs with the tab holes and ghten

ing the child-safe screws.

Please note that the life of baeries is limited. Therefore, when monitoring over

long periods and, in parcular, overnight, it is recommended to use AC adaptors

for both the camera and the monitor unit.

Warning:

1. Do not mix old and new baeries.

2. Do not mix alkaline, standard or rechargeable baeries

3. Remove the baeries during long periods of non-use.

4. Use only the AC adaptors supplied with the package.

Oponal Baery Pack:

The Monitor on your system has a built-in baery recharging circuit. Make sure

you only use the oponal baery pack (Item # 70077), as standard rechargeable

baeries will not recharge.

Note: Camera unit does not recharge baeries.

Meijer.com

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Pas de commentaire

MobiCam Digital DL Manuel d'instructions Page 10